An installer’s toolbag and checklist on a boundary wall at golden hour
Support

Security system maintenance and fault finding

Every security system degrades on a schedule. Batteries age, beams drift, lenses fog, fences slacken and vegetation grows into detection zones. Maintenance is the difference between a system that lasts a decade and one that quietly stops working in year three.

Systems do not fail suddenly

Almost nothing on a security system fails without warning. Batteries lose capacity over months. Beams drift after a storm. A camera that looked perfect in March is looking through a branch by December. The failure feels sudden only because nobody was checking.

The other half of the problem is knowledge. A technician meeting a system for the first time spends the first hour working out how it was wired. One who installed it starts diagnosing immediately.

01 / Scope

What a service visit covers

  • Battery testing under load and scheduled replacement
  • Charger output verification
  • Beam and sensor re-alignment
  • Camera cleaning, re-focusing and re-aiming
  • Recorder health, drive status and retention verification
  • Electric fence tensioning and earthing checks
  • Gate motor mechanical service and limit checks
  • Alarm walk-testing across every zone
  • IDS alarm system upgrades
  • Centurion gate motor servicing
  • Fault finding on systems we did not install

02 / Method

How we approach it

01

Diagnosis before parts

Intermittent faults are patterns, not single tests. We ask for the log — when it happens, in what weather, after what — before replacing anything.

02

Tested under load

A battery that reads fine at rest can collapse the moment a gate motor draws current. Resting voltage tells you almost nothing.

03

The whole system, not one discipline

A single visit covers alarm, cameras, fence and gate, because that is how the property actually works.

04

The same person, every time

Werner installed it and Werner services it. There is no handover gap between the person who built the system and the person who fixes it.

03 / Process

From first walk to handover

  1. 01

    History

    What has been happening, when, and which zone or camera is involved. Two weeks of notes saves two hours of fault finding.

  2. 02

    Full-system check

    Alarm zones walk-tested, cameras reviewed, fence tension and earthing checked, gate mechanics inspected.

  3. 03

    Power and battery

    Every battery tested under load, chargers verified, surge protection confirmed.

  4. 04

    Corrections

    Re-alignment, cleaning, tensioning and replacements done on the visit where possible.

  5. 05

    Report

    What was found, what was fixed, what needs attention next, and when the next visit is due.

04 / Ask anybody

Questions worth asking

Ask these of us, and of anyone else quoting you. A good installer welcomes them.

  • How often should a system like mine be serviced?
  • Can you take over maintenance on a system somebody else installed?
  • What is checked on a standard visit, and what is extra?
  • Will I get a written report of what was found?
  • Can maintenance be scheduled so certificates never expire unnoticed?

Common questions

How often should a security system be serviced?+

Annually as a baseline, and more often where outdoor detection, electric fencing or a heavily used gate is involved. Properties that have been through frequent power interruptions benefit from more frequent battery checks.

Will you maintain a system another company installed?+

Yes. Taking over an existing system is a large part of the work. The first visit takes longer because it includes documenting what is actually there.

Do you offer maintenance contracts?+

Yes — scheduled visits at an agreed interval, which is also how compliance certificates get renewed before they expire rather than after somebody notices.

Direct contact

Talk to Werner about maintenance & support

The owner does the assessment and the owner does the work. No call centre, no handover gap.