A sliding gate motor opened for servicing with its gears showing and tools beside it
Access & automation

Gate motor installation and repair

A gate operator only lasts as long as the gate lets it. We diagnose the mechanics before the electronics, match the motor to the actual load, and protect it against the supply conditions that kill boards and batteries.

Replacing the wrong thing

A slow gate is usually blamed on the motor. More often it is drag — misaligned tracks, worn rollers, a rack that has shifted — making a healthy operator work far beyond what it was specified for.

Fit a new motor without correcting the load and you have bought the same failure again, on a shorter timeline. That is why every gate job here starts with the motor released and the gate pushed by hand.

01 / Scope

What we install and service

  • Sliding gate motors
  • Swing gate motors
  • Boom gates and barrier motors
  • Overhead and garage door operators
  • Heavy-duty and industrial operators
  • Centurion Systems installations and servicing
  • Safety beams and obstruction detection
  • Remotes, receivers and keypad access
  • Battery backup sizing and replacement
  • Surge protection on the operator supply
  • Smart and app-based gate control

02 / Method

How we approach it

01

The gate is diagnosed before the motor

Released and pushed by hand along its full travel. If it does not roll freely, the mechanics are the fault regardless of what the panel says.

02

Matched to the actual load

Gate weight, travel and daily usage decide the operator. An undersized motor on a heavy gate is a scheduled failure.

03

Surge protection as standard

The inrush when supply returns is what damages boards, and a damaged charging circuit then destroys batteries. Protection is cheaper than either.

04

The manual release is part of handover

Everyone in the household should know where it is and how to use it before they need it in the dark.

03 / Process

From first walk to handover

  1. 01

    Mechanical inspection

    Tracks, rollers, rack, hinges, posts and physical stops checked with the motor released.

  2. 02

    Diagnosis

    Battery tested under load, charger output measured, limits and obstruction detection checked.

  3. 03

    Quote

    What is being repaired, what remains original, and what will be tested afterwards — stated in writing.

  4. 04

    Installation or repair

    Mechanics corrected first, then the operator fitted, limits set and safety devices aligned.

  5. 05

    Handover

    Manual release demonstrated, remotes paired, power-failure behaviour explained.

  6. 06

    Maintenance

    An annual service covering mechanics, battery, limits, beams and remote range.

04 / Ask anybody

Questions worth asking

Ask these of us, and of anyone else quoting you. A good installer welcomes them.

  • Does my gate roll freely by hand, and if not, what is causing the drag?
  • Is the operator correctly matched to this gate’s weight and usage?
  • Is surge protection included on the supply?
  • How long should the battery hold, and how will I know when it is failing?
  • What does the gate do when power returns after an outage?

Common questions

Are you certified on Centurion gate motors?+

Yes. Centurion Systems is the operator family we specialise in, and certification is available on request and shown on our About page.

Why does my gate battery keep failing?+

Repeated deep discharge during power interruptions, usually made worse by a damaged charging circuit after a surge, and by mechanical drag increasing the current draw. All three are checked on a service visit.

Can you repair a gate motor you did not install?+

Yes. Most of our gate work is on existing installations. Where parts are still available and the gate is sound, repair is usually the right call.

Direct contact

Talk to Werner about gate motors

The owner does the assessment and the owner does the work. No call centre, no handover gap.